Plumber & gas engineer in West Hampstead

West Hampstead is home for us. We're a Gas Safe registered plumbing and heating company based in NW6, close to West Hampstead's stations, and across West Hampstead and neighbouring Kilburn we install, repair and service boilers, carry out landlord gas safety checks, and fix leaks, taps and pipework.

  • Based right here in NW6
  • £120 repair visit, up to one hour on site
  • Boilers, repairs, servicing and certificates
Get a quote 5.0 on Google from 61 reviews
Reviews from NW6

What a West Hampstead customer said

“Very helpful, friendly, local (NW6) and high quality installation of a replacement gas boiler in a challenging environment. Would recommend James highly.”
Richard V. · Google review · February 2026

Nine in ten homes here are flats

The 2021 Census found that 89% of households in Camden's West Hampstead ward lived in a flat. Only 593 of the ward's 5,343 households lived in a whole house. The flats divide almost evenly: 45% are in purpose-built blocks, a Census category that takes in the area's mansion blocks, and 41% are in houses converted into flats or shared.

A flat shapes a boiler job from the start. The boiler is usually a combi tucked into a kitchen or a cupboard, its flue has to leave through the flat's own outside wall, and the condensate pipe needs a route to a drain. In a block or a conversion the outside walls often belong to the freeholder, so it's worth reading your lease before a flue position changes. In practice, a new boiler in the old one's spot is often the simplest answer in a flat. We check the gas pipe and the flue route before quoting, and allow for surprises behind the old boiler, like the crumbling wall on the summer job below.

Nearly half of West Hampstead rents privately

West Hampstead is a neighbourhood of renters. In the 2021 Census, 2,487 of the ward's 5,343 households, 46.5%, rented from a private landlord or a letting agency. Across Camden the figure was 35.6%, and only two of the borough's 20 wards had a higher share.

For landlords, that means a yearly gas safety check on every gas appliance and flue in each let. Between tenancies, HSE's guidance is that before a property is re-let, the appliances and flues must be safe and covered by an up-to-date gas safety record, with a copy given to the new tenants before they move in. Our landlord gas safety certificate page explains what the check covers and what the record shows.

Boiler installation in West Hampstead

Two of our 2026 Vaillant installs in West Hampstead, both close to our base, show the range. In June an older Glow-worm made way for an ecoFIT pure 835, with a larger gas supply run around the outside of a newly renovated house; the write-up is below.

In summer 2026 we replaced an old Vaillant TurboMAX in a mansion-block flat. Once the old boiler was off the wall, the wall behind it turned out to be badly deteriorated, so we boarded and strengthened it before hanging the new Vaillant ecoFIT Pure. The job also took in a Vaillant system filter, limescale protection, a flush and treatment of the heating system, and full testing and commissioning.

Limescale protection matters in NW6. Thames Water says all the water in its region is hard, and a combi heats that water every time a hot tap runs. Where the new boiler goes in the same place as the old one, a Vaillant costs £3,000 to £4,000 depending on its size, and our prices page sets out what moves that figure.

Boilers and plumbing in West Hampstead: your questions

How often does a landlord in West Hampstead need a gas safety check?

At least once a year. The Gas Safety (Installation and Use) Regulations 1998 require a landlord to have each gas appliance and flue they're responsible for checked within 12 months of installation, then at intervals of no more than 12 months. HSE adds that the record must be kept for at least two years, and existing tenants must get a copy within 28 days of the check.

Is the water hard in West Hampstead?

Yes. Thames Water, which supplies NW6, says all the water in its region is hard, because it passes through chalky limestone on its way to the tap. Hard water leaves limescale in kettles, taps and the parts of a boiler that heat water. Thames Water's tips include keeping hot water at 60 degrees and fitting a water softener or an electric descaler, and on a new boiler we add limescale protection where the system needs it.

Do you work in Kilburn as well?

Yes. Kilburn shares our NW6 postcode and sits right next to West Hampstead, but its homes are different again. In Camden's Kilburn ward, 68% of households live in purpose-built flats, and 16% get their heat from a district or communal network, the second-highest share in Camden (2021 Census). If your flat has its own gas boiler, we can fit, repair or service it every year; on a communal system the boiler sits in a shared plant room and belongs to the building.

Need a plumber or gas engineer in West Hampstead?

Call or WhatsApp for the quickest answer. Or leave your details and we’ll ring you back.

Heat exchanger being cleaned with a rotary brush during a service
Request a call backWe only use your details to reply to this enquiry.
Call now WhatsApp